Xbox One Wall mount with ventilation 2 screw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added honeycomb mesh to the top support in order to limit vent blockage
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 290
- Wydruki
- 1
- Wyświetlenia
- 1825
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of the mount done by MarMed but I made a honey comb/hex mesh pattern in TinkerCad that I have added to the top mount in order to minimize vent blockage. The top mount is basically just keeping the Xbox from tipping and not actually lifting anything so it should not be a strength issue using it. I used regular mounts on the bottom.
I printed the mount laying on it's side, like in the picture. I made a small brim of 3 layers to help hold the mount in place due to high infill gyroid, but it may not be needed.
Filament = SunLu PLA+ Black Silk
Supports = No
Brim = Yes (3 layer) but may not be required
Layer height = .20 because I didn't care about the time, but I'm sure .30 would work
Infill = 50% Gyroid. Maybe overkill but I would rather spend a few more cents in filament for that peace of mind.