Solder Stencil for FM Radio Kit to apply solder paste
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
worked great a few times for me.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 353
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
There is an ICStation EQkit FM radio electronic kit that uses through-hole components with the exception of one 16-pin surface mount FM radio receiver IC. I made this solder stencil for this 16-pin RDA5807FP surface mount IC. It is for applying solder paste to the bare circuit board in order to hot-air solder the surface mount component. I printed the stencil at 0.12mm layer height. Use a scraper to apply the paste, remove the stencil and carefully place the IC onto the thin layer of solder paste. When the solder paste is heated, the solder balls in the solder paste melt and get pulled onto the individual pads which separates the pins and solders down the IC. I've done a couple circuit boards this way and it worked well for me.