Sushi Gunkan Maki Container Box Remix

Remix of Lawof McKrispyKreme's sushi container for easier printing and scaling.

1. The original model had full spheres for the roe which require awkward supports. The roe shape has been simplified and has been chopped ~4mm from the bottom to give a large flat adhesion surface for printing & gluing into the cap. The cap has likewise been shortened to match.
2. The entire model has been scaled down to 88% to be able to print the roe with ~20g of PVB (see settings below). This way you can make it from the PVB Sample Pack in case you've got some left over from color testing (as i did).

Printing Details

Roe

• Printed with Prusament PVB at 0.2mm thickness with 5% gyroid infill. This is a good pattern since you'll be able to somewhat see the texture. This should use ~20g filament (which is enough to be able to make it from the PVB Sample Pack). Check your slicer to confirm usage before printing.
• Finish with isopropyl alcohol bath. I just used a small paintbrush to brush a few coats on and let it dry since I just wanted to smooth it a bit and didn't have the time to wait for drying, but you could experiment with a proper bath if you want to get better translucency.

Cap & Container

• Printed with Prusament PLA at 0.3 thickness. I found that thicker gives a better looking texture.
• Give the cap fuzzy skin with Prusa Slicer on all walls. For the container just give fuzzy skin to the exterior walls.
• Print the cap with supports due to the overhang
• In the attached pictures, the coloring for the seaweed is acrylic paint with a couple coats of matte clear acrylic varnish