Replacement Bar for Mind Reader Ergonomic Foot Rest
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement base adjustment bar part for the Mind Reader Ergonomic Foot Rest
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 348
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Public Domain
This is a replacement for the bottom center bar of the Mind Reader Ergonomic Foot Rest. The round section of the original bar had broken and I was asked if I could help fix it. I remodeled the part as closely as able in TinkerCAD and it seems to do the trick!
The new part is not open at the bottom to help with simplicity and rigidity. There are two holes in the bottom to reuse the two rubber feet from the original piece - I misplaced the one I measured when making the part so only one is pictured until I can locate the second. They friction fit in each and pull out easily.
You will need a larger printer for this as it's not a small part. I used PLA and 6 perimeters/layers on all four sides with 5% infill and it's probably a bit stronger than needed (and used over half a roll of filament). I might suggest printing with 4 or 5 perimeters/layers and use 20%-30% infill instead. My part feels stronger than the original but it may also be much more brittle.
Print Details | |
|---|---|
| Layer Height | .20 mm |
| Infill | 5% - 20% Gyroid (I used 5% but might suggest 20% - 30%) |
| Perimeters & Top/Bottom Layers | 4 - 6 (I used 6 but might suggest as low as 4) |
| Supports | Organic, on Support Enforcers Only |
| Filament | Overture Black PLA |