QIDI X-Plus X-Max Ribbon Cable Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a support bracket for the Qidi X-Plus and X-Max ribbon cable, it attaches to the top extruder cover. Without ...
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 262
- Wydruki
- 2
- Wyświetlenia
- 1532
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Version history
3.0:
- Bracket angled towards extruder cover to keep the cable from dipping down.
- You may have experienced that over time the cable will dip down using the V1 and V2 brackets, this angled design will prevent that.
2.0:
- Improved version that gently grips the ribbon cable keeping in steady, reducing the chance of it dipping down.
Support
All my designs and mods on Printables are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)
https://www.paypal.me/humebeamengineering
About
This is a support bracket for the Qidi X-Plus and X-Max ribbon cable, it attaches to the top extruder cover. Without support, the cable dips down when it gets extended, causing unnecessary stress on the cable as well as it getting greasy from the bearings and rods. It also touches the X-axis belt.
To install simply push in the tabs through the holes on the left side of the extruder cover then push down to secure it (use the lower holes) and route the ribbon cable over it.
Print Settings
Printer: QIDI Tech X-Max
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.2 mm
Infill: 20%
Filament: Prusament ASA Galaxy Black
Notes:
You may not need to use supports but I manually added some supports between the bracket legs that attaches to the cover.
