Large Air FIlter Housing v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Run your enclosure vent into this housing to filter fumes.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 1
- Wyświetlenia
- 143
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This fits these round generic filters from Amazon:
https://a.co/d/2N72xwb (Same size as Bissell MYAir)
It fits well as is for the tube end on this enclosure (taper fit):
It has an o-ring groove for standard 1/8" o-ring cord, but it is not required since the housing top will contact the filter before it fully seats. You make remix if you desire an 0-ring seal. This simply vents to the atmosphere form the air extracted from the enclosure.
I printed as a draft quality for speed, but added layer height modifier to the thread portions and to the angle out on the cover to be quality, 0.4nozzle.
Print the cover upside down, this will print with no supports since the vent holes are angle to print this way, print the o-ring channel sharp, and if you slow down with the height modifier to quality the bevel will print fine with no supports as well. Bottom needs no supports, I printed it 0.3 layer height.
It should print fine with larger nozzles, the threads are pretty big and offset for a nice fit. They don't need a water tight seal, its just for ease of replacement.