Silhouette Cameo 4 Matt Guide & Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two flush-fit guides that slot into the tray below, extending the bed to help prevent droop and provide alignment.
- Ocena
- 0 / 5
- Polubienia
- 117
- Pobrania
- 817
- Wydruki
- 1
- Wyświetlenia
- 4518
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Frustrated with registration failures, I've been working to mechanically align my prints so that I can get consistant cuts without tedious manual registration corrections.
These extensions were created to guide a cutting matt through with <1mm of clearance on either side, ensuring that it goes in at the right angle and placement the same way every time. Additionally, they help with droop a little bit - but some plastic card glued between the struts would probably help with this even more.
I wanted something quick and easy that could pop in and out to be put away since my floorspace is at a premium - so these flush-fit into the little grate within the existing tray. Inch the try out until the square peg can be slotted into the furthest slot on either side and then close it back for a nice flush fit.
Note: These were made to work with Silhouette brand matts. Clearances will probably be different with generic brands. If there's another common one I'd be happy to make an alternate version.
I printed mine with basic supports at .6 nozzle.