Logitech standalone USB shifter and Pedals
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a project box out house a Pro Micro knockoff board and two DB9 plugs to use for Logitech foot pedals and…
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 811
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a project box out house a Pro Micro knockoff board and two DB9 plugs to use for Logitech foot pedals and shifters as a standalone USB controller without the need for the Logitech Wheel base. Use your Logitech Pedals with a wheel of your choice.
This was created for this github project https://github.com/n-e-y-s/G27_Pedals_and_Shifter/tree/n-e-y-s_devel
Print with no supports, flat sides down. .20 or .30 layer should work fine. Use a m3 screw to secure the top, or glue for tighter fit. I used m3 nylon screws and nuts to secure the db9 plugs.
I use cheap pro micro boards from Alliexpress that press fit into place. There is a slot next to the screw tower to lift up the board if you ever need to remove it again.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
200
Infill:
100
Filament: Overture PETG Post-Printing =============
1st revision photo, slight changes made since
1st revision photo, slight changes made since
Category: Computer