Helion Animus Diff Spool insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a locked rear drive on a Helion Animus. I created an ez drop in spool to replace the spider gears in the…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 16
- Wydruki
- 1
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I wanted a locked rear drive on a Helion Animus. I created an ez drop in spool to replace the spider gears in the differential. Using the original pin in optional. The spool is clearanced for the tabs on the ring gear. To install, remove the differential from the car. Pull out the drive cups. Unscrew 4 screws on the ring gear. Split open the carrier and removed the side and spider gears and pin. Install pin (optional) into the spool. Insert the spool inside the carrier with the notched tabs facing the ring gear. Reassemble the rest. Remember to use a little bit of light lube on the ring and pinion.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Supports:
No
Resolution:
.2
Infill:
100%
Filament:
Overture PLE
Notes:
I used PLE at 100% infill for strength. I have not driven the vehicle since doing the modification but have bench tested the rear drive.
Category: 3D Printing