140mm - 90mm - Tube notch template
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tube template that goes over the pipe to trace the outline to be cut out
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 1571
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made to make a build easier in a first attempt into the world of fabricating build steel tubing.
90 mm to 140 mm OD tube/pipe
Lightning infill for speed - it will be quite soft and will split if squeezed too much, I had no reason for extreme use as it was only to be used a few times
A reduced size version also made it a bit faster - In hindsight, allowing a 2 mm tolerance for fitting over the pipe, could maybe do with a reduction from 92 mm to 91 mm - using a spacer to wedge the tool in place was easy enough
Maybe future iterations will address these issues
If shortened and using the lightning infill it took around 3 hours to print