HDB Support for FABtotum
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a printable support for HDB (Head Development Board) for FABtotum.
It is an alternative to the HDB Support from the FABtotum creators (http://www.thingiverse.com/thing:1832391).
It works for me, and fits my FABtotum very well. Hopefully it will fit other FABtotums too.
161228 UPDATE: I made a small change to make some room for the solder pads on the bottom side of the PCB. So now the PCB will lay more flat against the plastic.
Print instructions
Category: 3D Printer Parts Summary
This is a printable support for HDB (Head Development Board) for FABtotum.
It is an alternative to the HDB Support from the FABtotum creators (http://www.thingiverse.com/thing:1832391).
It works for me, and fits my FABtotum very well. Hopefully it will fit other FABtotums too.
161228 UPDATE: I made a small change to make some room for the solder pads on the bottom side of the PCB. So now the PCB will lay more flat against the plastic.
Print Settings
Printer: FABtotum
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.2mm
Infill: 100%
Notes:
I printed it with a 0.35 mm nozzle, but hopefully it will print OK with other nozzle sizes as well.
I used 100% infill, but it will probably work with lower values to.
Support is definitely needed!