Echine FPV Focal Extender
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I purchased budget FPV googles (Echine EV800) and the focal distance was very wrong for my very good eyes.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 341
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I purchased budget FPV googles (Echine EV800) and the focal distance was very wrong for my very good eyes. I don't wear glasses and have no vision problems. So, I wasn't sure why I had a hard time focusing on the display with these goggles and there is no way to adjust focus on this model. However, when I separated the two sections, I found I could focus very well if the halves were separated by about 2-3 finger widths. So, I designed this spacer to add about 1.5", which allowed me to focus with no eye strain and did not affect my field of view.
Print instructions
Category: R/C Vehicles Summary
I purchased budget FPV googles (Echine EV800) and the focal distance was very wrong for my very good eyes. I don't wear glasses and have no vision problems. So, I wasn't sure why I had a hard time focusing on the display with these goggles and there is no way to adjust focus on this model. However, when I separated the two sections, I found I could focus very well if the halves were separated by about 2-3 finger widths. So, I designed this spacer to add about 1.5", which allowed me to focus with no eye strain and did not affect my field of view.
Print Settings
Printer Brand: Prusa
Printer: Prusa Mk2
Rafts: No
Supports: Yes
Resolution: 0.2mm
Infill: 15%
Notes:
I printed with the tabs on the top surface using supports throughout. I do suggest removing the supports from inside the slot cavity as they are difficult to remove after printing and my printer bridges that gap just fine.