Bob-Omb Tissue Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Bob-Omb Tissue Holder I created in Fusion 360 Measurements: 17cm wide x 25 cm deep x 17 cm high
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 184
- Wydruki
- 1
- Wyświetlenia
- 1788
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the Bob-Omb Tissue Holder I created in Fusion 360.
Depending on your result the upper and lower body might not hold together strong enough to pull tissues out. I added some quickly designed interlocking hinges, which you can glue to the inside. That should hold everything in place.
Measurements: 17cm wide x 25 cm deep x 17 cm high
Printed on Anycubic Kobra using Anycubic and Overture PLA Filament
Print Settings
Rafts:
Yes
Supports:
Only really needed for the eyes. Depending on your printer upper and lower body might also need a few supports to get the bowls started.
Resolution:
0.3
Infill:
15%