7/14 Day Pillbox Organizer with Print-in-Place Hinge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
7/14 Day Pillbox Organizer with Print-in-Place living hinge
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 993
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
7 or 14 day pill organizer with 14 compartments. Prints in one piece without supports and folds to close. 165g filament used for the hexagon version and 170g filament used for the non-hexagon version. Should print fine in PLA but might last longer if printed in a more flexible material like PETG.
There is also a 2 compartment version availible that was used for testing the hinge. This version uses 36g of filament
0.2mm layer height recommended, 0.28mm may work as well if the ~5 bottom layers are 0.2mm. 40% Lightning infill was used to reduce the amount of filament but there isn't too much infill so any infill should be fine.
