Motorbike Power Distributor (Bus Bar)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Motorbike Power Distributor 12 V
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 141
- Wydruki
- 1
- Wyświetlenia
- 946
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
A motorbike power distributor.
In addition to the case, printed in PETG, you need a copper plate measuring 15 mm x 57 mm and 1.5 mm in thickness.
At both ends of the copper plate, I punched out two semicircles of 8 mm diameter.
A 7mm punch would work as well, but I only had an 8mm punch.
Then I drilled three holes for the M6, 12mm screws.
To prevent corrosion, I electroplated the copper with a layer of gold after drilling.
The bottom and top of the case are held together by two M3, 25mm screws with nyloc nuts.
The top of the case also pinches down the copper plate and holds it in place.