Onewing Glider
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hello, I would like to introduce you to my onewing glider model.
- Ocena
- 5 / 5
- Polubienia
- 62
- Pobrania
- 263
- Wydruki
- 1
- Wyświetlenia
- 2163
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
You can choose from two versions of the wings (with or without internal supports). The body is the same for both.
You need:
- rubber band
- skewers
- a lot of glue
Recommended printer settings:
Wings without internal supports:
- Brim
- 0,2mm
- Vertical shells - Perimeters 1
- Infill 0%
Wings with internal supports:
- Brim
- 0,2mm
- Vertical shells - Perimeters 1
- Horizontal shells - top 3
- Horizontal shells - bottom 3
- Infill 0%
IMPORTANT Note:
Throw the plane at a 5° angle DOWN, if you throw it up it will immediately lose lift under the wings.
The model is quite fragile and I broke a lot of them while modeling. I recommend landing in water (it floats). :D
ATTENTION - Different settings of the printer or different filament can shift the center of gravity of the aircraft.