Creality Ender S1 TFT50 display mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screen enclosure for a TFT50 with a Raspberry Pi 3B mounted. The enclosure is mountable to a Creality Ender 3 S1.
- Ocena
- 3 / 5
- Polubienia
- 23
- Pobrania
- 174
- Wydruki
- 2
- Wyświetlenia
- 1492
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This enclosure is designed to house a TFT50 screen with a Raspberry Pi 3B mounted on the back, and it can be easily attached to the Creality Ender 3 S1. To attach the enclosure, you can use the original screws of the stock display.
The design consists of three parts, with the "screen" part being the most important. The other two parts are for the optional back cover, which provides additional protection to the Raspberry Pi and screen. The back cover includes ventilation sleeves to allow for proper airflow and cooling of the enclosed Raspberry Pi and screen. Also there is one bigger sleeve which allows to attach a ribbon cable to the GPIO ports of the Raspberry.
Screen
To install the screen, first mount only this part onto the printer (as shown in the last photo). Then, slide in the display from below. It should fit tightly, so no screws or other fasteners are required.
Back Cover
If you choose to use the back cover, it consists of two parts that should be assembled together tightly. If necessary, sand down the grille or use glue to attach the parts together. After assembling, slightly lift the front of the printer and put the back cover in place. It should fit snugly, and if desired, you can use the four holes to attach it with screws.