1 / 3
Rookery Hot End Cradle 4010 Zombied No Inserts for Rook Printer — zdjęcie 1
1 / 3

Rookery Hot End Cradle 4010 Zombied No Inserts for Rook Printer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I didn't have the right M3 heatserts so modded this to hold six regular M3 nuts.

Ocena
0 / 5
Polubienia
11
Pobrania
56
Wydruki
0
Wyświetlenia
492
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU Lesser General Public License

I put M3 nut holders into the model and tightened up the nutsert hols to make them M3 clearance holes. I'm using this to hold the short 5015 fan shroud.

The nuts should be fully seated before attaching the cradle to the carriage. I use a short M3 bolt to pull them into place. When seated, they should not protrude or interfere with fit.

Print in ASA since it will almost touch the bottom of the heat sink, should be far too warm for PLA.

Many thanks to Gulsifer for sharing the Rookery design and for having made so many variants, and to Kanrog for the 5015 version.

Tagi