Cable-routing Z Belt Cover Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixes of Aiko Z belt covers for Voron 2.4 to reduce air mixing and junk falling below.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 109
- Wydruki
- 1
- Wyświetlenia
- 480
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
After some trial and error I found that the Hidden cable routing z belt cover mod by Aiko worked the best for me of the Z belt covers available. However, there were a couple things I decided to tweak. Same as Aiko there are A and B mirrored files.
- Fill the belt hole with a friction fit piece
- slot and notch versions
- slot was a pain to install so I ended up using notch
- Cut a slot for the rail to sit in
- The manual I started with directed have a 3mm gap but this cover is 5mm thick.
- Rather than move the rails I cut a notch they could fit in.
- Fill in the voron logo.
- this is mostly aesthetic, but it might help with air mixing.
I used 3mm thick foam left over from the panels to seal the underside of the 3 covers not routing a cable. Every little bit helps… maybe…
Foam can also be used with the notch style hex fill instead of the remix cover if you are worried about the belts rubbing on hard plastic.