Reefer 170 Ecotech Radion RMS tubing mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount that slides over the screw at the base of a Radion RMS light bracket which has a hole for airline tubing
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 436
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to dose kalkwasser into my tank in a relatively high flow area and thought the best place to do this was right into the main drain downpipe area. So I designed this to slide over the clamp screw of a Radion RMS light bracket. It has a hole for standard airline tubing to fit through and the angle is set so that it drops right over the main drain of my Red Sea Reefer 170. It fits into the recess of the light bracket so it doesn't turn or spin on the screw. I use a small 3d printed extension tube in the end of the airline to keep it straight as soft tubing is liable to sag.
The prints in black and blue in the photos are the same dimensions, just the angle of the airline tubing hole was improved in the blue one although it's a bad print and I haven't reprinted it properly yet.
I would print this with the longer surface of the top of the bracket face down on the print bed. Supports aren't necessary. You may need to use a drill bit to smooth out the airline tubing hole so that it will push through easily enough but you don't want it too loose.