1 / 8
Mitsubishi Outlander Rear Inverter Phase Cable Gland
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Many used Outlander Rear Inverters don't come with cable pigtails, with this gland you can replace it with generic conn.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 432
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (18)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (7)Powiązane
Versions
- With supports: The “skirt” and added layer above that covering the 6mm hole enable a print without further support. If the perimeters are printed from the inside out, the O-Ring groove can be printed without supports as well.
- Without supports: Add your own supports :)
- M20: The M20 version works for both motor and inverter, due to it's shallower profile.
- M25: The M25 version only works for the inverter!
Recommended Material & Print Settings
- 0.1mm Layer height for good thread resolution
- The M20x1.5/M25x1.5 thread can be tight if there is too much extrusion
- The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
- The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.
Additional Hardware
- 3x 49x1.5mm O-Ring
- 3x M20x1.5 or M25x1.5 Cable Glands
Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.