Connecting Pins for 3D Benchy Dry Dock Display Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Connects the dry dock(s) and base with friction without using any glue, allowing for future expansion.
- Ocena
- 4,714 / 5
- Polubienia
- 57
- Pobrania
- 455
- Wydruki
- 9
- Wyświetlenia
- 1673
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
The 3DBenchy Dry Dock (see origin of this model) requires you to use glue to affix the module, the base and the side panel.
For those who don't want to use glue, you can print this connector pin which connects the module and the base by friction without using any glue.
There are 2 connectors in this page:
- module-to-base connector
- module-to-module connector
The module-to-base connector has 2 parts:
- Required - the short pin, for when you have only 1 rack module vertically
- Optional - the tall pin, for when you have 2 rack module vertically (it will be too heavy for the short pin alone). Print both tall and short pin - the tall pin plugs into the short pin to become a single rigid support structure, and then it sits on 4 holes on the base plate.
The module-to-module connector connects two dock modules vertically. You will need to print 2 of these for it to work.
All print without support. I printed with PLA Matte (the same as my dock) with 0.2mm layer height without failure, and it fits snug.