Gasket Spacer for FoodSaver FM2000
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer that lifts the foam gasket of the FoodSaver FM2000, allowing you to use slightly worn gaskets.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have a FoodSaver FM2000, but the foam gasket is wearing out and doesn't seal well enough to pull a vacuum anymore. Unfortunately, FoodSaver has not had this gasket in stock for months, and my experience with third party gaskets has been less than acceptable. I designed this 1mm spacer to put down in the well that holds the foam gasket, lifting the foam gasket enough to get a good seal with my worn gasket
The cover photo shows the gasket installed in my FoodSaver. I forgot to take a picture of it before I installed it.
Scale this model's z-axis as needed for your FoodSaver. It is a pretty tight fit and I have not tried removing the spacer, so I made a -moreclearance version that can probably just be dumped out with gravity.
I printed this on a Sovol SV04, which has a bed large enough to print this in one piece. In case your printer is not large enough, you can cut the part into two pieces and install them individually in the gasket well.
Sliced with 0.25mm layers.
If you use this spacer, it will cause your foam gasket to get squeezed further and faster than if you don't. Only use the height necessary to re-acquire a vacuum seal. Add more spacers as the gasket continues to wear. I haven't tried it yet, but it may also be possible to print this model in TPU to make a replacement seal.