Epic Fantasy Football Trophy

The full version of this trophy is available on Cults and Etsy. That model does not require any purchased fittings and includes a place to put winner nameplates.

This modular trophy was designed to be printed and assembled in one of three versions: Basic, Elite and Legendary. The Elite and Legendary trophies are designed to be printed on a large bed surface ( >250mm) however they can be scaled down (recommended 90%) to fit on most printer beds. The parts necessary for each version are listed in the start of the part name and each of the versions require the parts that start with ALL. Fittings are highly recommended to allow for dismantling and/or upgrading however the parts can be glued together for permanent fixturing. 

The football text should be printed with a raft and full supports for best quality.

The text for the plaques and plates can be printed in place with the plates being printed directly on top of them for permanent fixturing.

NOTE for Elite and Legendary: The Thread Locknut in the Plaque Stand should be placed mid print using a “Pause at Height" command

-The following is a list of fittings required for each version-

Basic Trophy: > M4 x 0.7 mm Socket Head Screw, 8mm Long (x9)

> M4 x 0.7 mm Threaded inserts (Heat-Set) 4.7 mm length (x9)

> M10 x 1.5 mm Thread Flanged Socket Head Screw 50 mm Length (x1)

> M10 x 1.5 mm Thread Nylon-Insert Locknut (x1)

> Compression Spring 0.48" OD, 0.404" ID, 0.875" Long (x1)

Elite Trophy: > M4 x 0.7 mm Socket Head Screw, 8mm Long (x10)

> M4 x 0.7 mm Threaded inserts (Heat-Set) 4.7 mm length (x10)

> M10 x 1.5 mm Thread Flanged Socket Head Screw 50 mm Length (x2)

> M10 x 1.5 mm Thread Nylon-Insert Locknut (x2)

> Compression Spring 0.48" OD, 0.404" ID, 0.875" Long (x2)

> 1 / 4" - 20 Thread Hex Head Screw 6" Long (x4)

> 1 / 4" - 20 Thread Thread Nylon-Insert Locknut (x4)