1 / 7
Mitsubishi Outlander Inverter Aux Cable Gland — zdjęcie 1
1 / 7

Mitsubishi Outlander Inverter Aux Cable Gland

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Many used Outlander Inverters/Chargers come without cable pigtails, w/ this gland you can replace it with generic conn.

Ocena
5 / 5
Polubienia
8
Pobrania
36
Wydruki
1
Wyświetlenia
616
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

Versions

  • Blank: If you don't want to use the port, you can put in the blank plug to seal it off.
  • M16: For small diameter cables as in the original application this gland is sufficient.

Currently all versions are universal, so you can plug them into both ports of the inverter and the port of the charger. You have to know what you're doing!

 

Recommended Material & Print Settings

  • 0.1mm Layer height for good thread resolution
  • The 1.5mm pitch thread can be tight if there is too much extrusion
  • The test prints were made with PLA and PETG, if you want to use it in a car better use ABS, PETG, …
  • The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

 

Additional Hardware

  • 1x 31x3mm O-Ring
  • 2x M16 Cable Gland

 

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament to get this right.

Tagi