1 / 1
Creality Ender-3 S1 / S1 Pro : Z-axis parts — zdjęcie 1

Creality Ender-3 S1 / S1 Pro : Z-axis parts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Z-axis parts for the Creality Ender-3 S1 / S1 Pro

Ocena
5 / 5
Polubienia
84
Pobrania
566
Wydruki
2
Wyświetlenia
3309
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These are engineering duplicates of the original Z-axis parts for the Creality Ender-3 S1 / S1 Pro.

This includes the Z-axis stepper mount, upper lead screw bearing bracket, and the plastic lead screw nut spacer.

I made these because the default plastic injection molded parts started cracking, and I just couldn't get proper alignment of the stepper motor/lead screw/upper bracket so there wasn't any binding or rubbing.

Printing recommendations:

Print in sets (Stepper mount and Upper Leadscrew Support) or all at once. This will ensure no misalignment when assembling.

Material: PLA or PETG
Nozzle: 0.4 mm
Walls/Perimeters: 4
Infill: 20% Gyroid
Support: Standard. (Required for the stepper motor mount and the stepper motor relief boss on the bottom)
Build plate: Smooth - non-textured (Especially for the Z-nut spacers, depending on how straight your leadscrews are, they need to “wiggle” just a bit to compensate bent leadscrews. Put the smooth side to the X-axis metal plate)

Extra Note: In Cura, in the “Experimental” section, I would recommend setting “Slicing Tolerance” to “Exclusive”. This will improve the fit of the parts to extruded aluminum beams.

I am not familiar enough with Prusa Slicer to recommend a similar setting. If you know, please add a comment below.

You can get by with using PLA for the stepper mount, because the steppers don't get hot enough to cause any deformation. If you're paranoid about it, print with PETG.

Please note: These are engineer prints and there isn't much margin for play. The bearings are definitely “press fit” in the Upper Leadscrew Support (as they should be).

I highly recommend that you ensure that you have calibrated all steps for all axis (X, Y, Z), and your “flow rate” or “extrusion multiplier” is perfectly tuned, so you get as exact dimensional print possible. If possible, measure and enable backlash compensation, if it is available in your firmware.

When fitting to your printer, test the alignment of the leadscrews in the stepper coupler. Keep the coupler pinch screw loose on the leadscrew side, the leadscrew nut screws “snug” but not tight (they should wiggle just a bit) and lift the X-axis gantry up and down, carefully. The leadscrews should just drop into the couplers with little resistance. If they don't figure out why.. bent leadscrews, improper / misaligned / loose printed brackets.

Tagi