Pill organizer latch for Sukuos pill organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement latch piece for the Sukuos pill organizer from Amazon
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 392
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution
This is a replacement for the clasp, or latch mechanism from the Sukuos pill organizer I bought from Amazon. It's a nice organizer, but this piece broke after a while, making the organizer less functional. I printed it vertical with supports and on a raft to prevent elephant foot. Even a very small amount of elephant foot will make the bracket on that end not fit in place. Might need a bit of sanding to get it to move smoothly. I also added a little silicone oil to the brackets. I also coated the ends on the outside with CA glue to help prevent it separating at the print lines, since that area has the highest stress. So far it's working well for me.
Update: I've been using this for 6 months with no major problems. I did accidentally leave it in my car on a hot day once, and the PLA warped. I was able to straiten in out by heating my print bed up to 70C, setting the part on it and pressing it flat against the bed to straighten it. If I need to print it again, I'll use PETG.
If you're not sure if this will fit your organizer, here's the exact pill organizer I bought: https://www.amazon.com/gp/product/B07JQBZVX8/