Canon EOS 7D diopter wheel cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a great idea by Lamima, but that design was a little too short for my EOS 7D, so this is tweaked slightly. May…
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 58
- Wydruki
- 2
- Wyświetlenia
- 656
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This is a great idea by Lamima, but that design was a little too short for my EOS 7D, so this is tweaked slightly. May be a snugger fit.
Also incorporates a cutout to allow the pop-up flash to be used without removing the cover.
Made specifically to fit the Canon 7D, but tested on both a 30D and a 40D - the arm is slightly long for both of those but not in the way at all, fulfills its purpose.
Print Settings
Printer:
Voxelab Aquila
Rafts:
No
Supports:
No
Resolution:
.2mm, but whatever works
Infill:
100%
Filament:
eSun PLA+Grey
Notes:
Made to be snug, but it's it too much, a little sanding on the underside may be in order. Fast and easy print job - make a spare at least
Category: Camera