Wall mounts for Bambu Lab AMS (Old version, see description)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your AMS on the wall.
- Ocena
- 4,958 / 5
- Polubienia
- 307
- Pobrania
- 1314
- Wydruki
- 27
- Wyświetlenia
- 8300
- Oceny
- 24
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I've redesigned this model and release it exclusively on MakerWorld:
https://makerworld.com/en/models/207490-ams-wall-mounts-v2-0-fits-all-ams-versions#profileId-227597
This design is heavily inspired by the Wallmount for Bambu AMS model created by StefanWoX. I wanted my AMS unit slightly further from the wall and saw room for improvement so I spun up my own.
The AMS unit will sit ~63mm from the wall with these mounts which will allow you to fully open the lid.
Testing
I've included a test model so you can quickly print out a low quality piece to ensure the key parts will fit with your AMS unit. The test piece should fit flush into the last three rectangular slots. The end of the test piece will roughly be flush with the back of the AMS unit.
Printing tips
I opted to use PETG for my mounts with the following settings:
- 0.2mm layer height
- 6 wall loops
- 5 top and bottom layers
- 30% gyroid infill
- Tree supports for the screw holes (optional but will keep them round)