Delta-P Air Inlet Shroud

tAre you stuck with the MK3S+ because you bought yours and you didn't knew the mk4 was around the corner? Did the return time was already expired when the MK4 was announced? 
Do you feel the the need to add more stuff in your printer to fill the void?

Fear no more, here is my take on the air inlet for the vanilla setup, but this is for the Delta-P version, this was done in the most rudimentary way, in prusa slicer, with the least effort and knowledge, so don't expect much for it.

I did notice that the fan was still on a position where it probably catch a lot of hot air from the bed, this remix, can be just pressed against the fan.

Printed in PETG at 0.20mm with 15% infill (probably there is no problem is this is less than that) and no supports, with the inlet upwards (just in case).

This is inspired by Prusa i3 Mk3 90° Air Inlet (https://www.printables.com/model/54922-prusa-i3-mk3-90deg-air-inlet) and remix from 5015 Print Fan Shroud (https://www.printables.com/model/227361-5015-print-fan-shroud), MK3S+ print fan shroud (for Delta-P fan mod)  (https://www.printables.com/model/275681-mk3s-print-fan-shroud-for-delta-p-fan-mod) - not included.

Edit:

07/28/2023 - added a version 1 that should adjust to an m3 screw per request. this hasn't been tested though. PLA version added, not tested.