Vase Mode Dice Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you like your dice stored but you hate stringing and seams this one is for you!
- Ocena
- 5 / 5
- Polubienia
- 43
- Pobrania
- 136
- Wydruki
- 1
- Wyświetlenia
- 642
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This simple dice storage prints in vase mode with 0.8mm layer width and snaps together easily. It holds 7 dice in the standard format (26mm max diameter).
It prints fast with little material (20g). You need to print both parts and just clip them together.
I printed it in PETG at 30mm/s and 0.2 mm layer height in 1.5 hours, if you speed up a little this should easily be done in under 1 hour maybe even half an hour.
Two tips for the box:
always start from the outside and work your way to the middle when opening or closing opening it all at once will not work due to the geometry. If you print it in PLA it may be better to go for smaller layer widht to get some more flexibility as it is needed for opening and closing and go for high print temps to ensure layer adhesion (you don' t have to worry about stringing and other artifacts anyways).