Maracas

UPDATE! Print the screw horizontally, if you write it vertically it may break

Put something that can rattle in the bottom part and screw the top part.

Try different fillings, e.g. dried peas, beans etc
If you don't have something that can rattle, print Maracas_rattles (under STL)

For the handle there is a screw without a head that is screwed into the handle and the bottom part.

It is an advantage if you print the screw lying down with “Support on build plate only”

(A screw, printed standing, broke for me when I was testing the Maracas)

If the handle were to break off, for some reason, only the screw itself needs to be replaced.

SAFETY
If you are worried for small parts inside to come out if someone screws apart the Maracas then you can put some glue when you screw them together.
(Will never get apart again)

NOTE!

I had one problem with Overhang perimeter for the top part.

Just to cut those threds thou!