Deburring Tool holder for IKEA Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple holder for common Deburring Tools and two additional blades for IKEA Skadis pegboards.
- Ocena
- 4,8 / 5
- Polubienia
- 34
- Pobrania
- 271
- Wydruki
- 17
- Wyświetlenia
- 848
- Oceny
- 15
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
There are a few holders like this already, but I always found them way too bulky as they tend to give space for way too many blades - when all you do is 3D printing, the wear on these is so little that I really don't need many at hand. Therefore, I found two are enough as then you have one of every common type: standard, hardened steel and for small holes. Two inside a holder, one inside the tool - makes it fast to switch them out without needing much space on your pegboard.
The holder fits common Deburring Tools with a hexagonally shaped body, 12mm across flats (I attached an image so you get a better idea in case I use the wrong words here). My tool is from a company called Libraton and is made from aluminium; I highly recommend that one.
Print with support. Layer height has no impact, print as coarse or fine as you like - I used 0.24mm