MagSafe Charging Pad (Dual iPhone or iPhone and Watch)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual charging pad / station for the new MagSafe pucks that the iPhone 12 / 12 Pro uses.
- Ocena
- 4,5 / 5
- Polubienia
- 31
- Pobrania
- 152
- Wydruki
- 2
- Wyświetlenia
- 1895
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dual charging pad / station for the new MagSafe pucks that the iPhone 12 / 12 Pro uses.
The charging pucks just drop in to the cavities, and then are held in place with the screw in backs.
The cables are held in a similar way with a similar, smaller screw in retainer.
Print instructions
Printed in black PETG. Generic PETG profile used in prusaslicer. 0.2mm layer height, 10% infill.
No need for any supports if the top surface of the pad is down on the print surface (so that the cavities face up)
Print with top surface down, so that the cavities for the pucks will not require support. The threads on the covers and retainer may need a little finessing as they can be quite tight straight off the printer
[EDIT]
Added 4 additional STLs for a single phone & apple watch charging pad. This has not been printed, only modelled after a request in the comments.
[EDIT 09/11/20] Additional STL added - charging pad watch small. This should fit on the Prusa Mini.
For the dual phone pad:
1 x charging pad main, 2 x charging pad retainer, 1 x charging cable retainer
For the combined phone / watch pad:
1 each of charging pad watch, watch large retainer, watch small retainer v2, watch cable retainer
For the smaller phone / watch pad:
1 each of charging pad watch small, watch large retainer, watch small retainer v2, watch cable retainer