WARZONE Loot Box (Game) inspired PC case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
290mm GPU, SFX PSU, 2.5 HDD, ITX Motherboard.
- Ocena
- 0 / 5
- Polubienia
- 87
- Pobrania
- 334
- Wydruki
- 0
- Wyświetlenia
- 4354
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I highly recommend that you watch the full build video before attempting to build this!
Check out the video here:
You do not need threaded inserts for any parts of this build, even though you see it in the video, the design is changed so this is NOT required anymore.
Printed on CR10v2 and Ender-3, all parts are small enough to fit the Ender-3!
Tiny parts were printed using a 0.4 nozzle and 0.1 layer height on the Ender-3.
All large parts were printed with a 0.6 nozzle and 0.3 layer height.
All files are exported as .3mf, works the same as regular STLs, some files may appear outside the print surface in your slicer when you import them, so if you don't see anything, zoom out and it should be there somewhere.
When printing the butterfly latches, it's recommended to use a 0.4 nozzle or smaller and 0.1 layer height to make sure they rotate freely. May need to be “broken loose" with some pliers before rotating freely.
.STEP files files are also uploaded.
Total size approx. 470 x 210 x 210 mm
Room for graphics cards up to about 290mm in length.
See video linked above for walkthrough of entire build process including airflow, configuration etc...