Retainer clips for DVG deep dish counter trays
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hold the lid of DVG counter trays firmly closed. Several versions available
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 274
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Share Alike
I found that the lids of DVG counter trays doesn't clasp on very tight, which runs the risk of them falling off and spilling the contents everywhere, especially if you store your games vertically. These clips latch onto the trays with a satisfying snap and hold the lid firmly in place.
Available both in a thin version that can be placed anywhere along the edge of the tray, and longer versions that cover the entire short or long side respectively.
I have successfully printed these in PLA. PETG may also be an option if you want some more springiness (though I do not know if too much springiness decreases the clamping strength).
(I only tried printing the thin clips myself, so let me know if you have any issues with the longer ones. I did find that the thin ones are plenty strong, however.)