1 / 17
Spot Welder Enclosure — zdjęcie 1
1 / 17

Spot Welder Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure for common battery strip spot welder.

Ocena
0 / 5
Polubienia
14
Pobrania
56
Wydruki
1
Wyświetlenia
658
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

This is a complete enclosure kit for a common battery spot welder found on Amazon and other sites. I designed it so that the selection button lights up from the LED on the circuit board. There is no cleanup required except the point of the button may need the tiniest amount sanded down for the button to operate. See the photos for the orientation of the cable connections. The probe ends are slid through the holes first and then the input wires slip into a notch, (notch was a later update and not shown in photos). I designed the battery connector fittings and knobs too, they are included in the files but not necessary for the enclosure. There are marks on the bottom to align rubber feet attachment.

The button has a hole in it that is for a scrap filament to be inserted for alignment. A drop of Cyanacralite holds it in place.

The screw sizes are:

Lid, 4 screws, #6-32 x 3/8"

Board, 2 screws, #4-40x1/4 and 1, #6-32 x ¼"

Feet, ¾" square rubber with double side tape

Shrink tube, 2 pieces, ½" by 5/8" long

If there are any issues let me know, it's always possible I didn't upload the latest version. There was several prototypes to get to the final version.

Tagi