Tarmo5 Off Road Truck Body Kit - Remixed Cut in half
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have remixed JungleTim's design to not require a 300x300mm bed. I have printed this on a standard ender
- Ocena
- 5 / 5
- Polubienia
- 46
- Pobrania
- 185
- Wydruki
- 8
- Wyświetlenia
- 1579
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I have remixed JungleTim's design to not require a 300x300mm bed.
I have printed this on a standard ender and it can be printed on smalller beds.
The model has been cut in half and a brace peice has been added between the two halves. It also acts as a frame brace as such. You can still use the roof, bonnet, rear arm and the side rails from the original design but will require longer m3 screws.
I have also added in a mirrored version, this is optional with the only upside being so that you can get the same surface finish on both sides.
Depending on how straight your chassis is, you might have to pull it all together slightly.
lastly, thank you JungleTim for your work on this. It really transforms the Tarmo's looks and provides added protection!
Print Settings
Printer:
Mercury One
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
30
Category: R/C Vehicles
