1 / 3
Magnetic Closure Filament Sample Spool
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple filament sample spool that uses 10mm x 3mm magnets for closure
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Simple filament sample spool that uses 10mm x 3mm magnets for closure. I found that many of the sample spools I saw used too much plastic and/or the center area was too wide for some of the tighter wrapped samples.
Notes:
- I suggest only using 2 10mm x 3mm magnets for each side. As you can see in the pictures, I only use 2 of the magnet holes and it holds really well. I actually have twist the sides to get them apart. I think 4 would be hard to separate.
- Be very careful with the magnets around children!!
- Make sure to orient the magnets polarity and triple check before pressing the second magnet in!
- While they start as press fit, the magnets will come loose over time so I suggest using a couple drops of CA glue once polarity has been verified.