Add Parts for MP3DP V4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made some changes to the standard configuration of the MP3DP V4 made by @vicious1 .
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 23
- Wydruki
- 1
- Wyświetlenia
- 133
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Included are:
Side Panels for a bottom skirt. Side Panels v3-1.3mf
I built the frame with extra length on the uprights so I could mount the electronics underneath a panel. These do two functions. 1. The make it look cool! 2. They retain the panel that holds the electronics. I used 3mm ACM and the brackets are designed for that or any other 3mm material you use. You can scale in your slicer to make up any space requirement. Be sure that you redrill the bolt holes. I have not tried to scale for taller and am concerned about the nut trap.
Bed Supports. Bed Support End v6.3mf
I replaced the bed support with a “T” of 2020 extrusion. Please note that these are made for v-slot extrusion. This allows the bed to move on the three Z axis mounts and does not require a large plate under the bed.
Feet. 2020 Foot.3mf
Built to add feet to a piece of 2020 extrusion. Printed in TPU with 2 perimeters and 20% Cubic sub infill.