N scale depressed center flat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my version of a car to hold the IoTTStick with purplehat sensor board in N scale. This car lowers the center…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 398
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
This is my version of a car to hold the IoTTStick with purplehat sensor board in N scale. This car lowers the center of gravity approximately 3.5 mm below the truck bolsters compared to the version I downloaded. Designed to fit Microtrains Bettendorf trucks with medium extension couplers 003 02 022 (1003). You will need to drill out the hole to use their press fit pins. I used a .073" drill.
I printed my car upside down with supports to give the best surface for the truck bolsters to ride on.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2.5
Rafts:
No
Supports:
Yes
Resolution:
0.15mm layer 4 perimeters
Infill:
80%
Filament: any PLA any
Category: Electronics