Sovol SV01 & SV03 ultimate Support (Spool & Filament sensor)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Not convinced of the stock solution, I made this support for spool and filament sensor using almost everything that is…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 657
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Not convinced of the stock solution, I made this support for spool and filament sensor using almost everything that is supplied.
I made several prints and have not encountered any problems.
The filament falls plumb following a very natural path and absolutely does not affect the maximum printing height.
To use the supplied screws I used "Ruthex" type nuts (#4 M3 + #2 M4).
If the same type of filament sensor is used, the system is also compatible with Creality models. It has been found that some sensors have the exit hole 3mm forward, so I have prepared a supports (Support:NextG_5.stl) with 3mm more base. See photos.
Spool Holder used: https://www.thingiverse.com/thing:4268750
If you liked my project, help me grow. Please donate.
Thank you
Print Settings
Printer:
Sovol SV01
Resolution:
0.20
Infill:
20%
Filament:
Giantarm PLABlack
Notes:
Use Prusaslicer 2.3.0 with Support Paint-on
Category: 3D Printer Accessories