Light Stick Mounts for Skadis Pegboards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organize your KPop light sticks on Skadis pegboards with these mounts
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 206
- Wydruki
- 1
- Wyświetlenia
- 1704
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Organize your KPop light sticks on Skadis pegboards with these mounts!
Most files are prefixed with “Dxx” where ‘xx’ is the diameter in millimeters of hole that holds the light stick in place. The other files are prefixed with Exx-yy where xx and yy are the major and minor diameters of an ellipse. The best way to figure out which size to use is to measure the widest part of the handle and pick the next largest diameter, but if you'd like some pointers as to what size works with which light stick, check out this google sheet:
https://docs.google.com/spreadsheets/d/e/2PACX-1vR9ltdZ-tj-ov10Q8kdTMuQKMNGogBpH7ONsm3kzH1LlC200MGeiiaLYSNIphM6eZq8Y8sj4b_tXnND/pubhtml?gid=0&single=true
The examples pictured were printed in PETG at 15% infill with the 0.15mm STRUCTURAL preset. The mounts print upside-down (i.e. how they are in the STLs) to avoid the need for any supports. An outside brim may be needed to hold the two hook pieces down depending on the level of adhesion that your print surface has.