i3 Rework Print Fan 40mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 40mm print fan mount for those using Rework 1.0 extruder. This fan mount is attached to the body extruder with the…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
A 40mm print fan mount for those using Rework 1.0 extruder.
- This fan mount is attached to the body extruder with the two M3 used to secure j-head/E3D hotend,a concept I've seen here before in thingiverse.
Print Settings
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
40%
Notes:
I've printed this fan mount with ABS and FF coconut filament. While coconut/wood filament gives a very good (!) looking fan mount, ABS gives less weight, so I will recommand using ABS.
I didn't need supports, but I've integrated anyway at least for the base angle. You might need too for the screw holes in the sides (again, I didn't need to, but I didn't make supports for these this time) Notice in the pictures I don't use screws to attach the fan :
- I use ties, and I've been using rubber screws. I recommand them both.
Category: 3D Printer Parts