Telescope Eyepieces, 7mm, 32mm, 45mm, 52mm, 1.25" dia
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Eyepieces for astronomical telescope, 1-1/4" barrels
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 528
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
This project was inspired by Jerry Oltion's article in the September 2020 issue of Sky & Telescope, p. 74.
These are four eyepieces for an astronomical telescope made from lens sets available from Surplus Shed (surplusshed.com). These are based on the following items:
L3721 Reverse Kellner, 52mm fl
L3715 Erfle, 32mm fl
L3713 Reverse Kellner, 45mm fl
L1646 Reverse Kellner, 7mm fl
Each set consists of two or three lenses (eye, middle, field) ranging from 8mm to 36mm in diameter.
Each eyepiece consists of the following parts:
1.25" barrel with a 1.5mm pitch external thread,
Housing with a matching internal thread,
Two or three lens spacers, one each for the eye lens, middle lens (if used), and field lens.
Flexible eye guard.
I made these from ABS except for the flexible eye guards. ABS is more durable, lighter, and has a less glossy finish than PLA. The eye guards are printed from black TPU
The vertical resolution of the print is important to get acceptable quality on the threads. I printed mine at 0.12mm vertical resolution and a speed of 20mm/s. You can print all the parts without supports, but some files need to be flipped 180º when slicing.
I have compared these eyepieces with commercial eyepieces from Meade. The 3D printed eyepieces compare very favorably. There's a little distortion at the edges, and some chromatic aberration. A view of the moon shows color fringes on some of these designs, whereas the Meade eyepieces are color-free. The FOV of the 7mm eyepiece is very narrow. Contrast is as good or better than the Meade lenses, and I notice no internal reflections.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.12mm
Infill:
20%
Filament: Inland ABS & TPU Black
Notes:
Make all parts from ABS except for the flexible eye guards, which are TPU. Take care in assembling the lenses; they must be properly oriented and in the correct order. Surplus Shed provides an info sheet with the lenses, but doesn't give a lot of specifics about possible designs. They specify that the lenses "should be as close as possible without actually touching." My design has a nominal spacing of 0.48mm, which seems to work well. The clearance between the lenses and the spacers is 0.3mm. This seems to work well to keep the lenses in place but allows them to slip easily into the spacers. The vertical resolution of the print is important to get acceptable quality on the threads. I printed mine at 0.12mm vertical resolution and a speed of 20mm/s. You can print all the parts without supports, but both housings (internal & external threads) need to be flipped 180º when slicing.
Category: Physics & Astronomy