Team Assocated B74 Front Bumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a slightly extended front bumper for the B74
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 276
- Wydruki
- 0
- Wyświetlenia
- 727
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a slightly extended front bumper for the B74. It sits over the chassis and helps to protect the track from the front of the chassis and helps prevent you chassis protector from peeling off.
This part should be made out of solid TPU (nylon may work too). The hole in the center can be printed without supports and then must be poked or drilled out to get the screw through (this was done to make it easier to print without supports)
I have had a few people testing these and they are happy with them so far but I'm sure they will wear out a little faster than kit bumpers but they are cheap and easy to print.