Magnetic Holder for PET Geocaching container
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic Geocache Holder
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 556
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Holder for Geocaching container PETling for screw mount with woodscrews.
Dimensions
outside: 35x35,5x110mm
inner diameter is 25mm
Non printed parts
1x PET-ling diameter 25mmx120mm
1x PET-cork
1x Magnet 8x3mm or similar
2x M6 Nut
2x M6x12 screw (not stainless for the magnet)
2x Woodscrew 3,5x16mm
Print instructions
I printet it our of PETG with the 0,2mm quality setting (3 perimeter and 15% infill) an it tourned out perfect. In my case, no post-processing was required. Of course you can also give PLA a try but I thought PETG or ASA was the best because it will last longer outside.
Additional information
I used a bit of super glue to secure the magnet to the screw head which is in the holder. And some hot glue to seal the container from the inner side after drilling the hole for the screw in the PETling. The magnet holds the container very good but I recommended to not mount it up side down.