Aquarium Plant Anchor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this plant anchor to help hold down aquarium plants and to fertilize them
- Ocena
- 5 / 5
- Polubienia
- 94
- Pobrania
- 241
- Wydruki
- 1
- Wyświetlenia
- 3618
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was made to solve a problem with aquarium plants not staying in the substrate as well as to keep the fertilizer caplets down and near the plant's roots. The design has a small cage at the bottom that comes off and fits a fertilizer caplet, the cage clicks into place and acts like the point of the screw. You will need about 2 inches of substrate to use these anchors. If you don't plan on fertilizing and just want to hold a plant down you can screw the anchor in without the point. There is a key included in the files to help screw these into the substrate. Once the anchor is in place you remove the key then you push either a bundle of plant roots or a single plant into the anchor.
There are two options available for the anchors, clockwise and counter-clockwise depending on which you prefer.
The anchors we printed in black PLA and coated with shellac to make them aquarium safe. I printed the anchors at a 0.2mm layer height.