Wacom Intuos Pro tablet holder for IKEA Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hold your Wacom Intuos Pro (size M) on IKEA Skadis pegboards!
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 525
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This holder may not be of much universal use, I still thought to share it.
I specifically designed it to go onto the back of my table-mounted Skadis pegboard, else it would block a lot of space. Also, I wanted to slide it in and out of the holder, so there's minimal risk of it falling off in some way. That also means that you can also get it out this way, which might be hard depending on how your Skadis is mounted.
This was made for the older Intuos Pro tablet in size M from Wacom, but it should also fit the Intuos 4 and 5, probably 3 as well. I have no idea about the new Intuos models.
I made a closed and an open shape; they are wider than the studs, in case you want it symmetrical you can just mirror the 2nd one inside your slicer.
The holders are rather long, but at an angle a single one will print on a bed as small as 210x210mm. Print as coarse as you like. I recommend using a stronger filament like PETG, also I'd recommend using many outer walls instead of more infill.