1 / 3
Desk stand for Lavalier / Lapel clip-on microphones — zdjęcie 1
1 / 3

Desk stand for Lavalier / Lapel clip-on microphones

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A modular desk stand for Lavalier/Lapel-type clip-on microphones.

Ocena
5 / 5
Polubienia
22
Pobrania
245
Wydruki
1
Wyświetlenia
1397
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A modular desk stand for Lavalier-type clip-on microphones. The stand comes in three parts: Base, arm and replaceable mic clip. The arm is available in 200 and 250 mm length and clips into the base - no fasteners or tools required. I used the 200 mm long version for my print (see pictures).

The stand is elegant and lightweight, but super stable. The replaceable clip allows you to easily adapt it to your needs. Currently, there are two clip variants available: One for Lavalier mics with 5.3 mm diameter and one flat disk for clipping on mics with crocodile clamps.

For designing your own clips, you can use the existing STLs as a basis. Or you can sketch new parts in your CAD software of choice: The clip cross section is an equilateral triangle with sides of 5.7 mm length. The corners are rounded (R=0.5 mm). The clip hole in the arm is 10 mm deep.

 

Print Settings

  • Layer height 0.16 mm (arm & clip), 0.12 mm (base)
  • Line width 0.42 mm
  • Infill 15-20% (arm & clip), min. 30% (base)
  • 4 wall lines
  • 5-6 bottom layers
  • 6-9 top layers
  • Bed adhesion: 10 brim lines (clip only)
  • Supports enabled, support placement “everywhere”

Printing the clip can be challenging due to its small size. I recommend maximum cooling, as well as reducing the printing temperature by 10°C. It can be helpful to print 3 clips at once, to allow each layer more cooling time.

Approximate print times @ 60 mm/s: 200 mm Arm 1:10 h / 250 mm Arm 1:20 h / Base 3:00 h / Clip 0:05 h

Tagi